Fast Setting Cement Based Concrete Patching Material
Speccopatch a special formula, fast setting, cement based concrete patching compound material that requires only water for mixing and very little experience.
Speccopatch concrete patching compound may be used for indoor and outdoor applications, as well as vertical, horizontal, and overhead surfaces without forms. Initial setting time is only 12 to 18 minutes, and it may be shaved to the contours of the surrounding area.
Concrete patching compound can be used to repair concrete pipes, manholes, sidewalks, steps, driveways, ceilings, walls, curbs, panels, and expressways.
Speccopatch is ready for light traffic in 2 hours and standard traffic in 6 hours. Concrete patching material is ideal for applications under constant water contact or in high humid environments. Speccopatch concrete patching material may be mixed with water for a thinner patch to use on surrounding areas for a new look. .
For Use On:
- Use for repairs on aisle ways
- Anchoring Equipment
- Concrete Pipe
- Loading Docks
- Parking Lots
- Shop Floors
- and much more
- Easy To Use, Fast Setting
- Tenacious Bond
- Use on Horizontal, Vertical or Overhead Repairs
- Apply in Any Weather
- Compound Bonds to Concrete, Masonry, Wood
- Material is Stronger Than Concrete
- Saves Time & Money
- 7,270 P.S.I.
- 45LB. Tub
- Cover 3 Sq. Ft. at 1.5 Inches Thick
- 6 Sq. Ft. at 1 In
- 12 Sq. Ft. at .5 Inch
All areas to be patched should be clean and free of oil, grease, dirt, deteriorated concrete and any other contaminants. Etch slick surfaces to ensure proper bond. Clean, prepare and prime any exposed steel per I.C.R.I. guidelines. Always pre-wet the substrate to a S.S.D. (saturated surface dry) condition with no standing water on the surface. Mix only as much material as can be placed in 10 minutes. Place approx. 3.25 quarts (0.81 gal.) of water in a mixing pail and slowly add the 45 lb. of Speccrete® Speccopatch RS while continuously mixing with a mechanical low speed drill and paddle mixer. Higher quantities of bags may be mixed in a mortar mixer to speed the mixing process for larger jobs. Mix Speccrete® Speccopatch RS to a uniform, lump free consistency for a minimum of 60 seconds. A thick, creamy putty-like texture (zero slump) is considered ideal working consistency.
Apply Speccrete® Speccopatch RS concrete patching compound at a 1/4 inch minimum up to 0.75 inch (overhead) and 2.0 inch (vertical) maximum thickness per lift. If applying in successive lifts, allow the preceding lift to stiffen or harden before applying fresh material. Refer to technical data sheet for applications over 2.0 inches requiring possible aggregate addition. Always overfill the area to be patched. Force Speccrete® Speccopatch RS into the area to be patched by trowel and formed to the intended shape. Once the initial set has occurred, shave the patch to the desired finish. Always shave towards the bond lines. Finish with a steel trowel. Clean tools with water immediately after use. CAUTIONS: Do not feather the edge. Do not add previously mixed material to new batches. Do not re-temper or overwork the mix. Do not add excessive water. Do not apply to frozen or frost filled surfaces.
Refer to the technical data sheet for additional cautions.
NET WEIGHT: 45 lb. (20.45 kg)
COVERAGE: 22 sq. ft @ 1/4-inch-thick
YIELD: 0.40 cu. Ft
Only logged in customers who have purchased this product may leave a review.