Directions

Directions:

For best results, apply two coats to provide superior adhesion to floors. Always apply to a newly stripped floor. With a clean, rayon/cotton blend mop, apply by first “framing” the ar-ea to be finished, then go back and fill in the “framed” area with a gentle side-to-side mopping motion, being certain to overlap each pass slightly. Apply in a thin, unbroken line. If a rectangular applicator is used, be certain that each pass slightly overlaps the pre-vious one. Let each coat dry to the touch before recoating. Drying time is approximately 30 minutes. High humidity could prolong drying time. A fan can be used to reduce drying time. Allow the seal to set for 10 minutes before starting a fan. Do not use a fan in areas where dust could be blown onto sealer. Apply a second coat using the same method out-lined above. After 30 minutes begin applying a floor finish.

Floor Care Tips
– Do not use your stripping or rinsing mop, or bucket, for the application of floor sealers. Always start with a clean, previously wrung-out cotton/rayon mop and bucket. Save this mop and bucket just for the application of sealer.
– To avoid the accumulations of finish build-up in corners or on baseboards, always apply the first coat no closer than 12 inches from baseboards. Apply a second coat, and every other coat up to baseboards.
– Always apply even, medium coats. To ensure the application of medium coats, wring out the bottom half of a fully saturated mop.
– Discard unused sealer. Pouring unused sealer from your bucket back into the original container can spoil the good sealer.